ring those bells

I obtained a new low frequency oscillator module for my modular synth a couple of weeks ago. It’s called the Vilfo, from Pittsburgh Modular. This isn’t your typical LFO. Vilfo is an acronym for “Voltage Influenced Low Frequency Oscillator” and by voltage influenced they mean that it responds to CV quite differently than the normal frequency control that one would expect. This thing has a chaos streak in it that pushes and pulls against whatever you’re feeding it in an odd kind of way. My favorite use for it so far is to use it as a clock source, and then send it some other clock or sine wave. Normally, a -+10v signal would speed up and slow down a LFO. In this case it kind of makes the Vilfo hesitate some, then shoves it around a bit, then speeds it up, then stops it altogether. But not always.

So I had it drive a little sequence of bell ringing, where the bells are made with the Hertz Donut. The different bell-like tones are created by having the Z8000 sequencer ring the second oscillator on the Donut a bit differently each time the main sequence of notes repeats itself. The timing is all Vilfo, with all the hesitations and speed ups and downs caused by the aforementioned influencing, in this case by a Malekko Oscillator in LFO mode. I run the triangle wave from the Vilfo back into the sync of the Oscillator, which toys with the timing a little more. A little like a feedback loop.

I thought the result was appropriate for this holiday season…

a new case

Just a show-off post. I’ve been switching a lot of modules out and mostly into the synth, and yesterday put it all in a new Mission 9 case by Monorocket. As I put it through its paces with my son Wilson, I took a bunch of pictures, of course. I also shot video of the breakdown and build-up which I expect to edit and post soon.

The pictures highlight two new modules as well, the Malekko/Wiard Noisering and the Flame Tame Machine.

the Monorocket Mission 9
one ring to rule them all
Tame Machine in the house
the Monorocket Mission 9